Delta Touch Faucet Troubleshooting

• Disconnect your terminal from the batteries and make sure that your solenoid valve is connected properly.
• Disconnect the solenoid from the battery pack and wait for at least 30 seconds for the solenoid to be reset. This way, you will have water, however, the touch problem might still persist.
• Check if you have inserted the batteries correctly (positive and negative).
• Plug the battery back to see if the problem has been solved and if any of the touch areas are reacting to touch activation.
• If not, once again check if the cables are touching anything that is metal or crossing each other. If yes, adjust them.
• Make sure, that the cable of the touch sensor and the cable of the handle are not touching each other as this could be blocking your touch system. Readjust these wires appropriately.

If Only One Touch Area is Not Properly Working

• Check the wiring of the affected touch area and rearrange the wires properly.
• In case the problem persists, seek professional assistance as more than one components might be affected and need to be replaced.

Plumbing Services
 
Plumber in Inglewood, CA

Plumbing Service Provider

Contact us